bioneg.blogg.se - Led strip connector

LED STRIP CONNECTOR SERIES

The strip to strip Hippo connector connects 2 LED tapes together and doesn’t leave a gap. They are also available in a strip to strip version or a strip to wire version. They are available in 2 pin (for single colour strips), 3 pin (for dual color strips) 4 pin (for RGB strips) and 5 pin (for RGBW or RGBWW strips). We have Hippo connectors that can be used with IP20, non-water resistant tape and versions for IP62/IP65/IP67/IP68 water resistant tape. This will make a strong physical and electrical connection ensuring a reliable joint. Simply select the correct size Hippo connector, insert the tape and close the connector until it latches. Hippo Connectors are an excellent and reliable way of joining LED tape to tape or tape to cable.

5pin, 12mm wide PCB, 30-60leds/m, RGBW led strip.

4pin, 10mm wide PCB, 30-60leds/m, RGB led strip.2 pin, 8mm & 10mm wide PCB, 30-120leds/m, single color led strip.Workable for Non-waterproof led strip only: By adding metal teeth to the cover, the connector can better secure the LED strip.Īlso the connectors is better choice than a 90 degree connectors since they’re easier to work with and provide more flexibility. This design reduces resistance and spark discharge, making the connection more stable and secure. The connector uses a V-shaped pin with a center hole, and the contact point of the pad is twice as much as that of similar products on the market. The built-in elastic pin will press the pad when the LED strip is inserted, the connection only needs to be inserted and pressed.

LED STRIP CONNECTOR SERIES

SR series connector are specially designed for non-waterproof LED strips. it’s easy to use for a DIY project, just plug in the led tape under two tabs ,make the tape under the metal connectors ,then close the plastic cover. * May be used when silicone sleeve is removed.The connectors are quite useful and much easier than soldering, good quality with different width. Push 4-pin interface as far as possible into port.Align the 4-pin interface with the 4-pin port on the RGB controller, making sure that the arrows are lined up.Slide LED strip into connector such that the metal contacts rest directly over bare copper pads of LED strip.Align "+" terminal of cut end of LED strip with respective terminal of connector.Note the position of the "+" terminal printed on the connector cover, then open the cover.

Check that cut end of LED strip does not have solder.

Check that width of LED strip matches width of connector.

Resultant combined LED strip length should not exceed recommended maximum length of LED strip.

NOT for use with single color 2-conductor LED strips.

For use with non-waterproof color-changing 4-conductor LED strips with +BRG pin order.

Great for experimental work, as well as for individuals that would like to utilize cut sections of LED strips leftover from other projects. This quick connector is used to attach cut sections of color-changing (4-conductor) LED strips to a compatible RGB controller using a 4-pin interface, without the need to solder.

For non-waterproof flexible RGB LED strips with +BRG pin order.

Easily adds 4-pin male connector to cut end of compatible RGB LED strips.

Removable connection avoids having to cut LED strip in order to fix errors.

Quick and secure connection speeds up installation time.

Frustration-free, easy installation without soldering.